Couple of material scraps
furniture button for nose
old sweater - arm works best
permanent marker pen
Cut 2 snowman head pieces out of muslin following the cut line of the pattern. Sew on the stitch
line shown on pattern, leaving about an inch to turn the piece inside out. After stitching, turn
inside out and stuff firmly with the Polyfiber Fill. You can just hot glue shut the hole you used
to stuff (or sew it if you are ambitious!). I just hot glue and make sure that is the very top of his
head so it is covered up when you add the hat.
Use about 8" of a sleeve from an old sweater. (If the sweater arm is too large for his head, you
can cut it on the seam and make a new seam - either sewn together or lightly hot glued together.
Place the sleeve on the snowman's head so about 2" of the top of his head is covered by the
sleeve, and roll the bottom section up about 1 1/2", forming a cuff. Hot glue onto his head all the
way around. Now loosely tie a piece of jute around the top of the hat. Using about 10" of another
piece of jute, tie it so it is a circle and stick one end into the top of the hat, far enough in so when
you tightly tie the top of the hat, it will form a secure loop for hanging. Tightly tie the jute on the top
of the hat. Cut the ends off and add a small button to the center (see picture).
Using a permanent marker (might want to mark it first with a regular black pen for placement) add
the snowman's dots that make up his eyes and mouth (see photo). Paint the wooden button
orange and hot glue as picture shows. Make a bow from material scraps and hot glue to the
bottom of his face.